Low Clearance Access
Tool Compatibility
Interchangeability
The HYTORC Offset Link provides an extension for HYTORC Square
drive tools allowing operators to tighten bolts that are difficult or impossible
to reach with limited overhead clearance or nearby obstructions. The Offset
Link also work great where bolts protrude above the nut where standard
sockets won’t fit. The Offset Link provides interchangeable cartridges that
allow the links to be quickly interchanged in the field to fit different size nuts.
The HYTORC Offset Link delivers accurate torque from the square drive
tool to the fastener to minimize operator error and improve safety.
Offset Link
The Offset Link provides an interchangeable cartridge system that
allows the user to easily change out cartridges in the field to
accommodate a range of hex sizes. The Offset Link is compatible
with the HYTORC Washer which eliminates bending and side load
while increasing the safety and speed of all bolting operations
The Offset Link is compatible with all HYTORC Hydraulic, Pneumatic
and Electric Torque tools. The Offset Link comes in two basic drive types
compatible with either ¾” and 1” square drives. The torque multiplication
factor for each cartridge is clearly marked; simply multiply the factor by
the desired torque and set the torque on the tool for accurate and
repeatable bolting operations.
The Offset Link provides a convenient low-profile extension that
allows square-drive tools to reach bolts that are otherwise difficult to
access because of obstructions. The links essentially allow the square
drive tool to function as a low-clearance tool thereby eliminating the
need for additional tooling. This bolting configuration is ideal for
tightening fasteners with protruding bolts
